Set the netname on a micropaq monitor – Welch Allyn Propaq LT, Propaq CS and Micropaq monitor, Radio Configuration - Installation Guide User Manual
Page 6
6
80016835 Ver A
Welch Allyn
3.
Press
to make your selection. The radio authentication screen appears.
The monitor resets and restarts. The radio is now configured and encrypted with the
selected scheme. If further configuration is needed, follow the instructions in
configuration tool user interface”
Set the NetName on a Micropaq monitor
Use this procedure to change the network name assigned to the monitor (assuming that
the current network name is one of the pre-set names listed in the monitor Network
Name Menu). To set a custom network name, see
To change the network name
1.
Press
to access the Main Menu, then repeatedly press
until SERVICE MENU
is highlighted.
2.
Press
to display the Service Menu screen.
3.
Press and hold
and
, then press
to display the Network Name Menu.
If the current monitor network name is one of the following pre-set names:
WARNING Do not attempt to change the network name unless you are a
qualified biomedical service engineer or a Welch Allyn employee. Changing the
monitor network name causes the monitor to re-start and seek to connect with
the FlexNet network corresponding to the new name.
WARNING Change the network name in a non-clinical environment only.
com.protocol
demo.protocol
com1.protocol
com2.protocol
com3.protocol
com4.protocol
com5.protocol
com6.protocol
com7.protocol
com8.protocol