Welch Allyn Stryker Light Source For Q2002-00, Q2002-02, Q2002-04, Q2002-06 - User Manual - Manual (Page 13)

1-9
5. Reinsert the fuse holder by pressing it into the power connector until
it snaps into place.
6. If the new fuse blows, immediately contact Stryker Technical Service
at 408-754-2000.
Cleaning
1. Prior to cleaning, turn power off and disconnect the power cord from
both the wall outlet and the Stryker Light Source.
2. Clean the external surfaces by wiping with a cloth dampened with
mild soap and water or by using the following cleaning/disinfecting
solutions. DO NOT IMMERSE.
• Cidex, CidexPlus
• 70% isopropyl alcohol
• 10% mild bleach solution
• Metracide
• 10% Wescodyne
• Banicide
• Wavecide-01
3. Wipe clean the power cord by using the same cleaning/disinfecting
solutions listed above. Wipe dry with a clean cloth. Take care not to
get the plug prongs wet. DO NOT IMMERSE.
4. Do not plug the unit into a wall outlet until it is thoroughly dry.
NOTE: Do not sterilize or immerse the Stryker Light Source.