Welch Allyn ELSV-60 Light Source GE Sensing & Inspection Technologies - User Manual - Manual (Page 9)

www.ge.com/inspectiontechnologies
Lamp Replacement
CAUTION: Lamp may be Hot! Allow the lamp to cool before replacing.
NOTE: Use only GE Inspection Technologies replacement lamp SPL-600.
AVERTISSEMENT: Pour eviter les rique d’incendie. Utiliser une Lampe de
rechange a GE Inspection Technologies SPL-600.
DO NOT touch the lamp itself or the interior reflective surface, because skin
oils will cause premature lamp failure. If necessary, clean fingerprints with an
alcohol dampened cotton swab. Do not leave lint on the lamp.
1. Turn the unit off and disconnect the power cord from both the wall outlet
and the light source.
2. Loosen finger screw on Lamp Access Panel and pull out Lamp Tray.
3. Remove old lamp by rotating Lamp Spring Retainer away from lamp
spring, pulling lamp back and up and then unplugging lamp connector
from harness.
4. Install new lamp by plugging lamp connector into harness and inserting
the lamp into tray housing, ensuring alignment notches are in the 6:00
and 12:00 positions. Rotate Lamp Spring Retainer back over Lamp
Spring. Use only GE Inspection Technologies replacement lamp SPL-
600.
5. Push Lamp Tray back into light box and lock in position with the finger
screw.
6. Reconnect power cord.
User Maintenance
Lamp Spring Retainer
Lamp Tray
CAUTION:
Lamp may be
Hot!
ELSV-60 Light Source 9