Agency compliance statements – Welch Allyn ELSV-60 Light Source GE Sensing & Inspection Technologies - User Manual User Manual
Page 13

www.ge.com/inspectiontechnologies
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Class A Compliance Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
Caution: Any changes or modifications made to this device that are not
expressly approved by GE Inspection Technologies may void the user’s
authority to operate the equipment.
Note: To maintain compliance with FCC Rules and Regulations, cables con-
nected to this device must be shielded cables, in which the cable shield
wire(s) have been grounded (tied) to the connector shell.
Canadian Notice
This equipment does not exceed the Class A limits for radio noise emis-
sions as described in the Radio Interference Regulations of the Canadian
Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depas-
sant les limites applicables aux apparelis numeriques de la classe A prescrites
dans le Reglement sur le brouillage radioelectique edicte par le ministere des
Communications du Canada.
Agency Compliance Statements
ELSV-60 Light Source 13