Vinten Radamec HS-2010MED Pan & Tilt Head - Manual (Page 41)

HS-2010MED Installation
User Manual 3-5
4. Open the box containing the head. Remove and set aside any accessory
items and packing material.
5. Two people can then lift the head from its box and place it in position on
the pedestal or tripod.
6. Install the tilt locking pin to hold the tilt cradle in position (leave the lock-
ing pin in place until the payload is mounted).
7. Align the holes in the base of the head with the bolts in the top of the ped-
estal or tripod.
8. With at least one person supporting the head in position, start the four bolts
by hand, making sure that they are not cross threaded. It may be necessary
to move the head slightly to exactly align it with the bolts.
9. Use a 9/16” open end wrench to tighten the four bolts evenly until the head
is securely fastened to the pedestal or tripod.
Insert And Tighten 4 Bolts (1 Bolt Hidden In Photo)