Receiving & inspecting the unit introduction – Vintage Cellars CC-CX8800 User Manual
Page 5
www.cellarcool.com | Page 3
Receiving and Inspecting the Unit
Note: CellarCool units are manufactured in the USA and tested prior to shipment.
•
Lift only at the designated hand hold locations on the shipping container or fully support the unit from underneath. A shipment
may include one or more boxes containing accessories.
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
Review the Packing Slip to Verify Contents
•
Check the model number to ensure it is correct.
•
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information, contact CellarCool Customer Service immediately at 1(855)
253-5271.
Check the Accessory Kits for the following contents:
Kit One:
•
CellarCool Owners User’s Manual
Kit Two:
•
10' Power Cord
•
6 - Screws, #6 x 1 3/4 Hex Washer Head
•
6 - 3/8" Phillips Pan Head Machined Screws
•
1 - 10 ft. Drain Line tube, Plastic 3/8
•
1 - 4 1/2 ft. Insulation Foam
•
2 - Mounting Flanges
•
2 - Magnetic Deflectors for Air Control
Please leave the CellarCool unit in its original box until you are ready for installation. This will allow you to move the product safely
without damaging it. When you are ready to remove the product from the box, refer to
page 6-11 for installation instructions.
Note:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
RECEIVING & INSPECTING THE UNIT
Introduction
Thank you for purchasing a CellarCool cooling unit. We strive to provide the highest quality products and the best possible customer ser-
vice. If you have any questions about your CellarCool unit, please call us at 1(855) 253-5271.
This User’s Manual is intended to assist in the proper installation and maintenance of the CellarCool cooling system. In order to ensure the
longevity of your cooling unit, the equipment should be installed properly and have a proper care and maintenance schedule. Please read
and review this manual carefully and keep it for future reference.
What Is the CellarCool Cooling System?
The CellarCool system is a specialized refrigeration unit designed for one purpose only: to maintain the optimal temperature and humid-
ity levels conducive to the proper storage and aging of fine wines. It is a self-contained cooling unit designed to be used as a forced-air
through-the-wall unit. The CellarCool cooling system is especially designed for the use and application to maintain optimal conditions for
wine storage and aging. The system is fully self-contained and can be installed as a “Thru-The-Wall’ application. The standard “Through-
the-Wall” units are temperature controlled via air sensor. The CellarCool unit can be set at any temperature within the acceptable wine-
aging range of 50°F to 67°F. It is designed to cool 30°F cooler than the ambient temperature of the space to which it is exhausting.