Preparing the unit for installation, Installing the unit – Vintage Cellars CC-CX8800 User Manual
Page 12
Page 10 | 1-855-235-5271
CX 012014
PREPARING THE UNIT FOR INSTALLATION
Applying Insulation Tape
Locate the (2) precut pieces of black foam tape included with the
unit. To apply, simply peel back the white-paper adhesive covering
and place on one side of the mounting flange. This foam creates a
tight seal between the bracket and the wall.
Two Piece Mounting Flanges
The unit utilizes to mounting flanges that attach to each side of the
unit on the exterior side of the installation location.
INSTALLING THE UNIT
Installing the Unit
1. Slide the unit into the installation location from INSIDE the cellar, make
sure the controller side of the unit is inside of the cellar.
Note: If you use decorative moulding, it should be
attached to the walls and never to the cooling unit
itself. The moulding itself should be removable
incase the unit needs servicing.
Front of Unit
Cellar Wall