Vintage Cellars CC-CX8800 - Manual (Page 16)

Page 14 | 1-855-235-5271 CX 012014
VERSION 2 CONTROLLER FUNCTIONS
Button/Symbol Normal Functions
ON/OFF • Press and hold the on/off button for approximately 3 seconds to turn the unit on or off.
Note: This does not disconnect power from the unit. In order for the power to be shut off from
the unit, the power cord must be unplugged from the wall receptacle.
• This button also serves as an escape button.
Up and Down •
Use these buttons to scroll up or down a menu.
•
Press and hold the up button for approximately five seconds to manually start the defrost sequence.
SET • Press the set button once to view the set point, temperature of the air sensing probe.
•
Once the set button is pressed “SEt” will be displayed. Press the up or down arrows to scroll through
Pb1 and the set point parameter.
• Press the set button again to view any of these values.
• To change the set point, press the SET button. When “SEt” is displayed on the screen, press the SET
button once more. Use the up and down arrow buttons in order to change the value until the desired
set point is reached.
• Hold the set button for approximately 5 seconds to enter the CPSM (Customer Preference Selection
Mode) menu. (CPSM detail on next page)
Snowflake Constant - Unit is in cooling mode and the compressor and fans are running.
Blinking - The unit is calling for cooling, but must wait 5 minutes before restarting the compressor. This 5
minute delay serves as an anti-short cycle for the compressors protection.
Dripping Snowflake Unit is in defrost mode. The compressor and fans will be turned off during this cycle.
Compressor On
Unit is in Defrost Mode Alarm is Present
Temperature Measurement
Menu Navigation
& Value Increase
*Press and hold
to manually enter
defrost mode.
Power On/Off
(hold for approx. 3 seconds)
& Escape
Menu Navigation
& Value Decrease
Probe Value &
Alarm Folder
*Press and hold to
enter the parameter
menu.