Vetter SP 60 - Manual (Page 6)

Vetter Safety Cushion SP 60
Page 5/30
2. Description of product
The self-aligning VETTER safety cushion SP 60 consists of a dual
chamber system. It is also equipped with an innovative pressure
regulation system.
A minimum of 4 persons are required to assemble and disassemb-
le it. The external covers are made of inflammable resistive and rot
resistive material (according to DIN 4102 B1) and has a combinati-
on of welded and sown seams.
The VETTER Safety Cushion SP 60 is produced according to the
requirements specified in DIN 14 151, Part 3.
2.1 Correct use according to instructions
The safety cushion is inflated by connecting and starting the blo-
wer.
The ventilation openings on all 4 sides prevent over-inflation of
the cushion.
The safety cushion should be used when it is not possible to carry
out rescue with other means (e.g. aerial ladder trucks) or when it is
necessary to use the safety cushion owing to lack of time.
Possible injury cannot be excluded in every single case when
using the safety cushion.
The safety cushion is only permitted to be used in emer-
gencies and only for person rescue! It is strictly forbid-
den to use it for exercises and shows!
2.2 Technical data for safety cushion
1. Blower 5. Other deventilation openings
2. Inflation hose 6. Positioning loops
3. Landing area with marking 7. Packing covers
4. Deventilation system (on both
sides)
8. Type label, imprinted
4
2
8
7 6
5
3
1