Vetter SP 60 - Manual (Page 10)

Vetter Safety Cushion SP 60
Page 9/30
Packing cover for the safe-
ty cushion is available and
free of damage.
Any other objects must not be placed on the safety cushion du-
ring transport or storage.
Only store the safety cushion in a dry room when it is clean and in
a dry condition.
The life duration of the product can be shortened by being sub-
jected to outside influences (e.g. heat from direct sunlight, tempe-
rature deviations etc.).
Optimum storage temperature (min to max): -20°C to +50°C
3.3 Packing plan
Before packing the VETTER safety cushion check for damage.
Safety cushions are only to be packed after inspection!
The safety cushion must only be packed when it is clean and dry.
Completely deflate the safety cushion. To do this, switch off the
blower and let the air escape out of the cushion.
Only start packing when the air has completely escaped out of
the safety cushion.
Lay out the safety cushion evenly.
Smooth out the landing area (Fig. 2).
The initial position is the front side with the connection hoses for
the blower. Fold in the side to the left up to the inflation hoses
(Fig. 3).
Turn over the right-hand side of the cushion up to the inflation
hoses (Fig. 4).
Once again fold both sides to the middle until the width of the
packing cover is reached (Fig. 5).
Now roll the safety cushion in the direction of the inflation hoses
as tightly as possible (Fig. 6).
The width of the rolled up safety cushion must not exceed the
width of the packing cover.