Vetter SP 60 - Manual (Page 17)

Page 16/30
The safety cushion is operationally available after inspection and main-
tenance work has been carried out.
5. Possible defects: safety cushion
Problem/Defect Solution
The safety cushion does not align
itself correctly.
Check to see if parts of the safety
cushion have been caught up. In
this case, switch off the blower
and eliminate the defect immedi-
ately. Inflation can continue after
this has been done.
Check to see if the ventilation
openings are in perfect condi-
tion, including rubber rings. If
necessary align the rubber rings
so that the ventilation openings
remain closed.
Check to see if the blower is set
to maximum power, correct this if
necessary.
The hoses are bent. Switch off the blower and realign
blower and hoses.
Possible defect: blower
Ramfan: Refer to the operating instructions for the blower from Page 27
onwards
Leader: Refer to the operating instructions for the blower from Page 29
onwards
6. Repetitive inspections
Safety cushions are only permitted to be repaired by the manufacturer.
Maintenance work is only permitted to be carried out by persons who
have undergone special training by the manufacturer in maintenance
and repair work and are authorized to do this by the manufacturer. In
addition to this, they must work in a maintenance shop authorized by
the manufacturer and have a knowledge of the safety and accident pre-
vention regulations.
The following come solely into consideration for safety cushion inspec-
tion:
for Annual Inspection
The specialist according to the preliminary remarks in GUV-G 9102.
for the Main Safety Inspection
The specialist according to the preliminary
remarks in GUV-G 9102 in addition to extra
training by the manufacturer or a trainer
authorized by the manufacturer.