Vetter SP 60 - Manual (Page 20)

Vetter Safety Cushion SP 60
Page 19/30
3. Inspect the following parts and visually check for recognizab-
le damage in the assembled condition
9 Landing area with marking
9 Packing cover
9 Side covers
9 Quick snap-in connection on the blower
9 Floor covers
9 Inflation hoses
9 Horizontal separation covers
9 Ventilation openings
9 Internal connection covers
9 Rubber bands on the ventilation openings (exchange if ne-
cessary)
9 Seams
9 Positioning loops
9 Blower (according to manufacturers instructions)
4. Inspection of the inside area for foreign bodies (clean if neces-
sary)
5. Documentation (test report filled out, type label marked, ins-
pection entered into the inspection log book)
Maintenance and repair work must only be carried out by the ma-
nufacturer.
Contact the manufacturer if there are any doubts about safety or
reliability of the Vetter safety cushion!