Vetter SP 60 - Manual (Page 12)

Vetter Safety Cushion SP 60
Page 11/30
It must be ensured that only the original blower supplied by Vet-
ter is used because only this one is permitted by the inspection!
Before connecting always make certain that the switch on the blo-
wer is positioned to OFF.
Only perfectly working and tested safety cushions are permitted
to be used!
The assembly location is mainly dependent on the operational si-
tuation and local conditions.
The assembly location must, as far as possible, be free of any sharp
or pointed foreign bodies. The safety cushion is to be protected
against heat.
3.5 Preparations for operation
Remove the safety cushion from the vehicle and lay it out on a
sufficiently large free area.
The exact assembly location is determined by the head of opera-
tion.
Release the packing cover.
The pictogram on the cover shows the direction for rolling out the
cushion.
Open the cover and lay out the inflation hoses.
Ramfan blowers
The blowers are assembled onto the inflation hoses of the safety
cushion via a snap-in connection.
Lay the inflation hoses with the eyes over the pins and then ten-
sion the snap-in connection using the ratchet until the inflation
hoses are fixed to the blower.
Finally ensure that all 4 eyes lay on one pin thus ensuring stabili-
ty.
Make certain that the hoses are solidly
connected to the blower!