Rice Lake TradeRoute HL Series - M2000 Scale - Manual (Page 13)

9
indicate the status of all the scales that are part of the total. For example
scale 1 may be at the center of zero, but channel 3 might not be at zero. The
center of zero indicator would then not illuminate reflecting that we are not
at zero.
To set the indicator back to single channel mode, select a channel followed
by the print select
3.2.3 Scan mode
Scan mode allows the indicator to cycle between the scale channels that are
enabled. The indicator will automatically switch the display to the next
available channel and pause for 3 seconds before switching to the next
channel. To stop scanning press a channel key followed by the print select
key.
To enter scan mode press 5 followed by the print select key.
3.2.4 Gross/Net
Pressing 6 followed by the print select key switches between displayed net
weight and gross weight.
3.2.5 Pound/Kilograms selection
To change the displayed units on the display press 7 followed by the print
select key. The indicator will toggle the displayed units on the display from lbs
to kgs or kgs to lbs. The units that the indicator uses as a default when
turning on the indicator is determined by the power up setting set in
calibration.
3.2.6 TEST display
To test the display segments press 8 followed by the print select key. All the
segments in the display will light up for a short period of time.