Rice Lake Survivor 390HE Hostile Environment Digital Indicator - Manual (Page 6)

2 SURVIVOR 390HE Installation Manual
1.2 Front Panel Keypad
Figure 1-1 shows the 390HE front panel keys and the key functions assigned in normal mode.
The symbols shown above the keys in Figure 1-1 (representing up, down, enter, left, right) describe the key
functions assigned in setup mode. In setup mode, the keys are used to navigate through menus, select digits
within numeric values, and increment/decrement values. See Section 3.1.3 on page 9 for information about using
the front panel keys in setup mode.
Labels under the keys in Figure 1-1 describe the key functions used in piece count mode. See Section 6.0 on
page 26 for more information about counting operations.
Figure 1-1. Front Panel Key Functions in Normal Mode
1.3 Display Annunciators
The 390HE display uses a set of LCD annunciators to
provide additional information about the value being
displayed. Figure 1-2 on page 3 shows these
annunciators and their meanings.
G
The displayed weight is a gross weight.
N
The displayed weight is a net weight.
Scale is at standstill or within the specified motion
band. Some operations, including zero, tare, and
printing functions, can only be done when the
standstill symbol is shown.
Center of zero. Gross weight is within 0.25
graduations of zero. This annunciator lights when the
scale is zeroed.
Indicates that a tare has been entered. The tare value
can be entered by pressing the
TARE
key on the keypad
or by sending the KTARE EDP command. See
Section 5.0 on page 22 for information about the EDP
command set.
lb, kg, PC
Three arrow annunciators on the right side of the LCD
display indicate the units associated with the
displayed value. The bottom arrow annunciator (PC)
is lit when the indicator is in piece count mode. The
top and middle arrows, labeled lb and kg, show
primary and secondary units, as described below:
•
If the displayed weight is in pounds, the top arrow
(lb) is lit; if kilograms, the middle arrow (kg) is
lit.
• If the primary unit of weight is pounds, the middle
(kg) arrow is lit for secondary units—or, if the
primary unit is kilograms, the top (lb) arrow is lit
for secondary units, unless the secondary unit of
weight is the same as the primary unit.
• If neither primary nor secondary units are pounds
or kilograms, the top arrow is used as a primary
units annunciator and the middle arrow is used as
the secondary units annunciator. A set of
replacement overlay decals is included in the parts
kit for units other than pounds and kilograms.
See Section 3.2.2 on page 13 for information about
configuring primary and secondary display units.
Switch between
primary and
secondary units
Send data to
serial port
Set gross weight
to zero
Switch between
gross, net, and
piece count mode
Acquire tare
NORMAL MODE KEY FUNCTIONS
T
MODE ENTER SAMPLE PRINT
ZERO GROSS
NET
TARE UNITS PRINT
B/N Units T