Rice Lake OB-350 Loadrunner Series Onboard Weight Indicator - Manual (Page 17)

Technical Settings 13
6.3 Alarms Menu
6.3.1 Alarm Setpoints
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
lb
Allows configuration of the audible alarm.
Table 6-1. Alarm Setpoints Menu
Parameter Choices Description
Alarm Alarm ON Turns alarm on.
Alarm OFF Turns alarm off.
Output Output Normal +12 VDC to power and alarm on power connector.
Output Invert -12 VDC to power and alarm on power connector.
Gross Gross PPCO Not used (custom packer-plate configuration only).
Net Sounder Alarm will display speaker and beep when net weight
reaches Alm value entered.
Net PPCO Not used (custom packer-plate configuration only).
Inc Sounder For use with inclinometers only – activates alarm when
angle reaches above incline (inclinometer setting) in
degrees.
Inc PPCO Not used (custom packer-plate configuration only).
Gross Sounder Alarm will display speaker and beep when gross weight
reaches Alm value entered.
Alm Alarm Weight
Value Edit value of the net or gross weight for alarm.
Hys Hysteresis Value Not currently available.
Trigger Off
On 2,5,10 seconds – selectable delay prior to alarm
activating in seconds.
6.3.2 Set Alarm
1. In MENU, select Alarms .
2. Press (OK)
3. Two setpoints appear. Select Alarm 1 .
4. Pressing (OK) toggles between ON and OFF . Select ON .
5. Pressing (OK) toggles between Output Normal and Output Invert .
6. Pressing (OK) toggles between Gross-Sounder , Net-Sounder ,
Gross-PPCO or Net-PPCO .
7. Select Alm . The alarm (sounder or flashing beacon) will activate at
weight displayed. To change target weight, press edit and set the alarm
setpoint using techniques in previous steps.
8. Select HYS , reset tolerance is edited in lb using techniques in previous steps.
9. Select Trigger, then press (OK) to toggle between: OFF , 2 , 5 or 10 seconds.
10. When all settings are correct, press (OK) to confirm.
11. For alarm 2, select Alarm 2 and repeat steps 7-10.