Rice Lake OB-350 Loadrunner Series Onboard Weight Indicator - Manual (Page 16)

12 OB-350 Operators Manual
6.0 Technical Settings
6.1 Calibration and Setup
To allow for on-vehicle installation variations, an initial and periodic system calibration is required. The first
calibration should take place a couple of weeks after the onboard weighing system has been used in service.
(OK)
Symbols
Keys
When selecting symbol, press the corresponding key below the symbol.
6.2 System Menu
6.2.1 Entering Pin Code (Password)
1. In MENU screen, select System .
2. Press (OK).
3. Press to select Pin .
4. Press (OK) to display PIN input screen.
5. Enter default password 0350.
• Press or to number 0-9.
• Press to move cursor left.
6. Press to enter code.
7. Press (OK) to accept the password.
8. Press to back up to MENU.
9. To Set PIN, select PIN, press (OK) and repeat 2 - 6.
Password or PIN is needed for every calibration & calibration change.
PIN codes can be reset to a new code of your choice, select Reset and
repeat steps. This is not recommended, loss of custom password will
require serial number of unit and may take up to 48 hours to process the
code.
Note
6.2.2 Entering PUK Code
Important
For use if a custom password is used, which is not recommended.
1. In SYSTEM screen, select PUK .
2. Press (OK). PUK code enter screen and unique PIN reset code is
displayed.
3. Call RLWS at 800-472-6703 and give the unique five-digit number
displayed. RLWS will provide a NEW four digit PIN code.
4. Press or to number 0-9.
5. Press to move cursor left.
6. When PIN is entered press to enter code.