Rice Lake Farm Bars - IQ plus 390-DC - Manual (Page 6)

2 IQ plus 390-DC Installation Manual
1.2 Front Panel Keypad
Figure 1-1 shows the IQ plus 390-DC front panel keys and the key functions assigned in normal mode.
The symbols shown above the keys in Figure 1-1 (representing up, down, enter, left, right) describe the key
functions assigned in setup mode. In setup mode, the keys are used to navigate through menus, select digits
within numeric values, and increment/decrement values. See Section 3.1.3 on page 11 for information about
using the front panel keys in setup mode.
Labels under the keys in Figure 1-1 describe the key functions used in piece count mode. See Section 6.0 on
page 28 for more information about counting operations.
Figure 1-1. Front Panel Key Functions in Normal Mode
1.3 Display Annunciators
The IQ plus 390-DC display uses a set of LCD
annunciators to provide additional information about
the value being displayed. Figure 1-2 on page 3 shows
these annunciators and their meanings.
G
The displayed weight is a gross weight.
N
The displayed weight is a net weight.
Scale is at standstill or within the specified motion
band. Some operations, including zero, tare, and
printing functions, can only be done when the
standstill symbol is shown.
C e n t e r o f z e r o . G r o s s w e i g h t i s w i t h i n 0 . 2 5
graduations of zero. This annunciator lights when the
scale is zeroed.
Indicates that a tare has been entered. The tare value
can be entered by pressing the
TARE key on the
keypad or by sending the KTARE EDP command. See
Section 5.0 on page 24 for information about the EDP
command set.
Indicates that the battery charge is low.
lb, kg, PC
Three arrow annunciators on the right side of the LCD
display indicate the units associated with the
displayed value. The bottom arrow annunciator (PC)
is lit when the indicator is in piece count mode. The
top and middle arrows, labeled lb and kg, show
primary and secondary units, as described below:
• If the displayed weight is in pounds, the top arrow
(lb) is lit; if kilograms, the middle arrow (kg) is
lit.
• If the primary unit of weight is pounds, the middle
(kg) arrow is lit for secondary units—or, if the
primary unit is kilograms, the top (lb) arrow is lit
for secondary units, unless the secondary unit of
weight is the same as the primary unit.
• If neither primary nor secondary units are pounds
or kilograms, the top arrow is used as a primary
units annunciator and the middle arrow is used as
t h e s e c o n d a r y u n i t s a n n u n c i a t o r. A s e t o f
replacement overlay decals is included in the parts
kit for units other than pounds and kilograms.
See Section 3.2.2 on page 15 for information about
configuring primary and secondary display units.
T
ZERO GROSS
NET
TARE UNITS PRINT
T
B/N Units
POWER
ENTER SAMPLE MODE PRINT
I / O
Switch between
primary and
secondary units
Send data to
serial port
Set gross weight
to zero
Switch between
gross, net, and
piece count mode
Acquire tare
NORMAL MODE KEY FUNCTIONS