Rice Lake Farm Bars - IQ plus 390-DC - Manual (Page 15)

Configuration 11
3.1.3 Front Panel Configuration
The IQ plus 390-DC indicator can be configured using a series of menus accessed through the indicator front
panel when the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Figure 3-2. Front Panel Key Functions in Setup Mode
Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 3-2).
The
UNITS ( ) and PRINT ( ) keys scroll left and right (horizontally) on the same menu level; ZERO ( ) and
GROSS/NET ( ) move up and down (vertically) to different menu levels. The TARE key ( ) serves as an Enter
key for selecting parameter values within the menus. A label over each of these keys identifies the direction
provided by the key when navigating through the setup menus.
Figure 3-3. Setup Mode Menu Navigation
Menu Menu Function
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, and digital
filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate indicator. See Section 4.0 on page 22 for calibration procedures.
SERIAL Serial Configure serial port.
PROGRM Program Set power-up and standby modes, counting scale functions, regulatory mode, unit ID and
consecutive number values.
P FORMT Print Format Set print format used for gross, net, and counting scale tickets. See Section 7.0 on page 29
for more information.
VERSION Version Display installed software version number.
Table 3-1. IQ plus 390-DC Menu Summary
T
ZERO GROSS
NET
TARE UNITS PRINT
T
B/N Units
POWER
ENTER SAMPLE MODE PRINT
I / O
Move LEFT /
Previous
Move RIGHT /
Next
Move UP /
Increment Value
Move DOWN /
Decrement Value
ENTER Value
SETUP MODE KEY FUNCTIONS
1 st Level
Parameter
Default value
2 nd Level
Parameter
Value Value Value
1 st Level
Parameter
2 nd Level
Parameter
When moving through values below the first menu level, press to return to the level
above. Press or to move to the next parameter on the level above.