Document Outline

• About This Manual
• 1.0 Introduction
  • 1.1 Operating Modes
  • 1.2 Front Panel Keypad
  • 1.3 Display Annunciators
  • 1.4 Indicator Operations
    • 1.4.1 Toggle Gross/Net/Piece Count Mode
    • 1.4.2 Toggle Units
    • 1.4.3 Zero Scale
    • 1.4.4 Acquire Tare
    • 1.4.5 Remove Stored Tare Value
    • 1.4.6 Print Ticket
    • 1.4.7 Acquire Parts Sample
• 2.0 Installation
  • 2.1 Unpacking and Assembly
  • 2.2 Enclosure Disassembly
  • 2.3 Cable Connections
    • 2.3.1 Cable Grounding
    • 2.3.2 Load Cells
    • 2.3.3 Serial Communications
  • 2.4 Enclosure Reassembly
  • 2.5 Battery Installation
  • 2.6 AC Adapter
  • 2.7 Board Removal
  • 2.8 Replacement Parts
• 3.0 Configuration
  • 3.1 Configuration Methods
    • 3.1.1 Revolution Configuration
    • 3.1.2 EDP Command Configuration
    • 3.1.3 Front Panel Configuration
  • 3.2 Menu Structures and Parameter Descriptions
    • 3.2.1 Configuration Menu
    • 3.2.2 Format Menu
    • 3.2.3 Calibration Menu
    • 3.2.4 Serial Menu
    • 3.2.5 Program Menu
    • 3.2.6 Print Format Menu
    • 3.2.7 Version Menu
• 4.0 Calibration
  • 4.1 Front Panel Calibration
  • 4.2 EDP Command Calibration
  • 4.3 Revolution™ Calibration
• 5.0 EDP Commands
  • 5.1 The EDP Command Set
    • 5.1.1 Key Press Commands
    • 5.1.2 Reporting Commands
    • 5.1.3 The RESETCONFIGURATION Command
    • 5.1.4 Parameter Setting Commands
    • 5.1.5 Normal Mode Commands
  • 5.2 Saving and Transferring Data
    • 5.2.1 Saving Indicator Data to a Personal Computer
    • 5.2.2 Downloading Configuration Data from PC to Indicator
• 6.0 Counting Operations
• 7.0 Print Formatting
  • 7.1 Print Formatting Commands
  • 7.2 Customizing Print Formats
    • 7.2.1 Using the EDP Port
    • 7.2.2 Using the Front Panel
    • 7.2.3 Using Revolution
• 8.0 Appendix
  • 8.1 Error Messages
  • 8.2 Continuous Output (Stream) Format
  • 8.3 ASCII Character Chart
  • 8.4 Front Panel Display Characters
  • 8.5 Conversion Factors for Secondary Units
  • 8.6 Digital Filtering
    • 8.6.1 DIGFLx Parameters
    • 8.6.2 DFSENS and DFTHRH Parameters
    • 8.6.3 Setting the Digital Filter Parameters
  • 8.7 Test Mode
  • 8.8 Software Revision History
  • 8.9 Specifications
• IQ plus 390-DC Limited Warranty