Rice Lake Farm Bars - IQ plus 390-DC - Manual (Page 43)

Appendix 39
Figure 8-6. Front Panel Key Functions in Test Mode
8.8 Software Revision History
The following list summarizes the principal software changes made for Version 1.1:
• New SMPRAT parameter on the CONFIG menu provides selectable A/D conversion rate ranging from
3.75–30 Hz.
• A/D gain (ADGAIN) and A/D offset (ADOFFS) functions removed from TEST menu.
TEST Menu
Function Description
A/DTST Display A/D test
Press and hold Enter key to display raw count from A/D converter.
DEFLT Default parameters
Press and hold the setup switch, then press the Enter key to reset configuration and calibration parameters to
factory default values. This function is equivalent to using the RESETCONFIGURATION EDP command followed
by the RS (reset) EDP command.
PRTCFG Print configuration
Press the Enter key to print the indicator configuration to the serial port. This function is equivalent to using the
DUMPALL EDP command.
Table 8-5. Test Menu Functions
T
ZERO GROSS
NET
TARE UNITS PRINT
T
B/N Units
POWER
ENTER SAMPLE MODE PRINT
I / O
Move LEFT
Move RIGHT EXIT
Not used
ENTER
TEST MODE KEY FUNCTIONS