ProgressiveRC 8 PowerLab - Manual (Page 33)

ENTER .
6. During charging:
Press INC or DEC on the Primary unit to view charging data. Data will be
displayed on each PowerLab 8 for the pack connected to that unit.
Press ENTER on the Primary unit to override the charge and discharge current
(for all units).
To stop charging on all units:
On the Primary unit, press and hold ENTER. You’ll see CHARGER STOPPED.
Press
ENTER to return to the User Preset menu.
7. When charging is complete, each unit will “beep beep beep” several times and the
display will show ELAPSED [time] / [chemistry] DONE. On the Primary unit, press
INC
and DEC to review charging data screens. Data will be displayed on each
PowerLab 8 for the pack connected to that unit.
Tip: You can also monitor charging data, and view data in graphs, in the
Charge Control Software. In the Cells, Int. Res. and Supply tabs, use the
drop-down lists to display data from a specific Expansion Channel unit.
Note: The operation is now complete, but the “session” remains open so you
can review collected data. Once you press and hold ENTER, data collected
during the operation will be discarded. If you disconnect the pack before
ending the session, PowerLab 8 will display a “PackRemoved” error. This is a
non-critical error, and you can ignore it in this situation.
Note: NiMH, NiCd and Lead Acid user presets may switch to trickle charge
(depending on how the preset is configured) when charging is complete.
8. After all units have completed charging, on the Primary unit press and hold ENTER .
Screen displays CHARGER STOPPED.
9. On the Primary unit, press ENTER or BACK to return to the User Preset menu.
10.
Disconnect the packs from all units.
33