ProgressiveRC 10S FMA Cellpro User Manual
Page 15
15
Defining presets
You can define up to six preset charging configurations. Each preset consists of a name, a chem-
istry and a charge current. See “Selecting a preset,” earlier in this manual, for instructions on
selecting a preset for charging.
Note: Remember that presets can be overridden at the charger. Preset changes made
at the charger are retained in the charger until manually changed again, or until a new
group of presets is downloaded to the charger. When you connect the charger to the
computer and launch the Charge Control Software, the program uploads and displays
the presets stored in the charger.
Perform all preset operations in the Presets tab.
To define a preset:
1. In the Name field, enter a name for the preset.
2. In the Chem field, select the chemistry.
3. In the Amps field, select the charge current.
4. If this preset will be used to charge a 6s to 10s pack, activate the Single Pack option (this
enables the charger to treat Ch1 and Ch2 as a single channel).
To download presets to the charger: Click Update Charger. The charger will beep when
downloading is complete.
or
To ignore changes and restore the previous presets: Click Cancel.
To restore the factory settings: Click Factory Default, then click Update Charger.
Note: This restores the factory default presets, and also resets the LCD contrast,
speaker settings and auto scroll settings.
Setting charger options
1. Click the Options tab.
2. Set options as desired:
LCD Contrast sets the contrast of the charger’s LCD display. The display will be easier
to read in bright conditions when the contrast is high.
Auto Scroll Cells ON option, when activated, directs the charger to scroll through screens
during charging. Auto Scroll Seconds controls how long each screen is displayed.
Speaker Volume controls the loudness of the charger’s speaker. If you want the charger
to confirm when you press the Mode button and Start/Stop button, activate the Button
Clicks ON option. Deactivate the Speaker ON option to mute the charger.
Optimize for Accuracy balances cells to 1mV. The charger can take an additional two to
five minutes to balance the cells. Optimize for Fast Charge ends the charge at 0.1C.
3. Click
Update Charger.
or
If you don’t want to apply the changes, click Cancel.