Oldcastle BuildingEnvelope HP-1750 - Manual (Page 26)

26 JULY 2011
H P - 1 7 5 0 I N S T A L L A T I O N M A N U A L
Web Address: www.oldcastlebe.com
Phone: 1-866-OLDCASTLE (653-2278)
SSG - INSTALLING - FACE CAPS
1/4"
3/8"
WHEN INSTALLING FACE CAPS
USE DEADBLOW HAMMER AND
IMPACT CAPS AT LOCATIONS
OF GLAZING CLIPS ONLY.
CAP INSTALLATION NOTE:
TO INSTALL FACE CAPS. LOCATE
CAP ONTO CLIPS AT EACH END. PRESS
FIRMLY AGAINST CAP UNTIL GASKET IS
COMPRESSED AGAINST GLASS AND STRIKE
AT PREVIOUSLY MARKED LOCATIONS OF
GASKET CLIPS. WHEN INSTALLED PROPERLY
CAPS SHOULD RESIST ROTATION.
MARRY WEATHER SEAL
TO HORIZONTAL GASKET
NOTE: LEAVE 1/4" GAP
IN HORIZONTAL GASKET
AT EACH VERTICAL
JOINT