Cabletron Systems SEHI-22FL - Manual (Page 60)

The Configuration Screen
SEHI User’s Guide 7-11
The following sections explain each field on the Configuration screen.
I/F
The number of the interface corresponding to the channels over which
packets with that IP Address pass. On the SEHI, this value is “1.”
IP Address
Displays the IP address of the SEHI.
SubNET Mask
Displays the subnet mask for the SEHI. A subnet mask is a 32-bit quantity
which “masks out” the network bits of the IP address. Do this by setting
the bits in the mask to 1 when the network treats the corresponding bits in
the IP address as part of the network or subnetwork address, or to 0 if the
corresponding bit identifies the host.
MAC Address
Displays the physical address associated with the interface.
Default Gateway
Displays the default gateway for the SEHI. This field is not defined until
an appropriate value is entered. The default gateway identifies the default
gateway device that forwards packets to other IP subnetworks.
Serial Port Application
Displays the port application setting as CONSOLE.
Baud Rate
Displays the Baud Rate setting of the device attached to the SEHI through
the serial port. The setting for the serial port is 9600.
Port Enable Override
This command lets the user override the Disable Port settings in the
Device Statistics screen to enable all ports in the stack.
SEHI Book Page 11 Friday, April 19, 1996 10:46 AM