Cabletron Systems SEHI-22FL - Manual (Page 30)

Installing the SEHI
SEHI User’s Guide 4-7
To stack the SEHI together with an SEH non-intelligent hub, proceed as
follows:
1. Attach the SEHI HubSTACK Interconnect cable to the “OUT” port on
the rear panel of the SEHI as shown in Figure 4-6.
2. Attach the other end of the SEHI HubSTACK Interconnect cable to
the “IN” port on the rear panel of the SEH.
To stack SEH non-intelligent hubs together, proceed as follows:
1. Attach the SEH HubSTACK Interconnect cable to the “OUT” port on
the rear panel of the SEH as shown in Figure 4-6.
2. Attach the other end of the SEH HubSTACK Interconnect cable to the
“IN” port on the rear panel of the SEH next in the stack.
Figure 4-6 Stacking the SEHI
SEH HubSTACK
Interconnect Cables
SEHI HubSTACK
Interconnect Cable
SEH INTERCONNECT
SEH-22FL 100BASE-FL HUB WITH LANVIEW®
OUT IN
SEH INTERCONNECT
SEH-22FL 100BASE-FL HUB WITH LANVIEW®
OUT IN
165210
SEH INTERCONNECT
SEHI-22FL 100BASE-FL HUB WITH LANVIEW®
OUT
SEH INTERCONNECT
SEH-22FL 100BASE-FL HUB WITH LANVIEW®
OUT IN
SEH INTERCONNECT
SEH-22FL 100BASE-FL HUB WITH LANVIEW®
OUT IN
SEHI Book Page 7 Friday, April 19, 1996 10:46 AM