beautypg.com

Figure 10: ip addresses, Figure 10 – Kontron SYMKLOUD MS2900 Web User Manual

Page 18

background image

18

www.kontron.com

Quick Start Guide

Figure 10: IP Addresses

When configuring the MS2900 system, set up your equipment (e.g., a laptop) to use the same subnet as the
MS2900 platform. Use the 1GbE RJ-45 management port (leftmost, marked ‚MNGT‛ on the hub faceplate) on
the active hub to connect your equipment to the MS2900 platform. This is a 10/100/1000 Mbit connection.

Configuring Processor Nodes

Use KVM through the SMWI (see Section 6.1.1) or serial access (see Section 4.1.2) to connect to the
processor nodes.

Once the processor nodes are configured, you can then configure the fabric GbE interfaces to meet your
specific needs.

Configuring Switches

To configure a switch, type in the pre-configured master switch IP address 192.168.10x.10 (Figure 10,
footnote 2) in your web browser to access the switch SMBStaX™ GUI.

Figure 11 shows the port mapping for the switch.

This manual is related to the following products: