Kontron OmniView - Manual (Page 7)

OmniView – User’s Guide (V1.)
6 www.kontron.com
3.
General Safety Instructions for IT Equipment
Please read this chapter carefully and observe the instructions for your own safety and to ensure
correct use of the device.
The chapter also contains information on approval and interference suppression of your device.
The device has been built and tested by Kontron in accordance with UL/IEC 60950-1 and left the
premises in a perfectly safe condition.
In order to maintain the safe condition and ensure safe operation, the user must observe the
instructions and warnings on the device and in the manual.
 The device must be used in accordance with the instructions for use.
 The electrical installations in the room must correspond to the requirements of the local
(country-specific) regulations.
 Take care that there are no cables, particularly power cables, in areas where persons can trip
over them.
Do not use a power cable in sockets shared by a number of other power consumers. Do not use
an extension cable.
 For DC power connection: The unit is only completely disconnected from the DC main power
source, when the DC power cord is disconnected either from the power source or the unit.
Therefore, the DC power cord and its connectors must always remain easily accessible.
 Do not place the device in direct sunlight, near heat sources, or in a damp place. Make sure the
device has adequate ventilation.
 Only devices and components which fulfill the requirements of an SELV circuit (safety extra low
voltage) in accordance with UL/IEC 60950-1 may be connected to the interfaces of the system.
 All plugs on the connection cables must be screwed or locked to the housing wherever
possible.
 The device is designed to be mounted and operated only in the position described in this
document. The proper mounting is a vertical (or close to) position with the interfaces
downwards.
 This device generates heat during operation. Make sure it is adequately ventilated. Do not
cover the ventilation holes in the display housing.
 Maintenance or repair on the open device may only be done by qualified personnel authorized
by Kontron, who is aware of the associated dangers.
 The device has no components internally that requires access or any set up by Kontron
personnel. If the unit malfunctions or a situation is encountered that requires that the unit be
opened, then return to Kontron for maintenance.
 Only approved original accessories (optional parts) approved by Kontron may be used.