Cleaning the filter mat – Kontron KISS 2U KTQ87 User Manual
Page 40
10. Maintenance and Prevention
KISS 2U V2_MB_SBC – User's Guide (Version 1.00)
10.2. Cleaning the Filter Mat
The filter mat (Fig. 36, pos. 2) is inserted in the filter mat holder (Fig. 36, pos. 4) at the front side of the fan slide-in
module (Fig. 36, pos. 5). The soiling of the filter mat is caused by the pollution of the operating environment. A heavily
soiled filter mat can cause excessive heating of the device. For this reason we recommend to clean the filter mat as often
as necessary. The filter mat can be replaced during operation of the system.
1
2
3
5
4
5 Fan slide-in module
4 Front access panel
3 Filter mat holder with knurled screw
2 Filter mat
1 Front side of the KISS 2U V2 platform
Fig. 36: Detail with filter mat holder on the fron side of the KISS 2U V2 platform
To replace the filter mat, proceed as follows:
1.
Open the front access panel (Fig. 36, pos. 4).
2.
Loosen the knurled screw that secures the filter mat holder to the fan slide-in module (Fig. 36, pos. 3 and
Fig. 38, pos. 5).
3.
Pull the filter mat holder out from the positioning holes (Fig. 37, pos. 3) in the direction marked with the arrow
(Fig. 36) and lift it off.
4.
Remove the dirty filter mat.
5.
Clean the filter mat as follows:
Rinse in water (up to approx. 40°C/104°F; you may add a mild commercial detergent).
It is also possible to beat it, suction clean it or blast it with warm compressed air.
If the filter is soiled with greasy dust, you should rinse it with warm water with degreaser added. Do not clean the
air filter mat with a piercing jet of water or wring it out.
6.
After cleaning and drying the filter pad, place it in the filter mad holder (see Fig. 39).
7.
Reattach the filter mat holder to the front side of the fan slide-in module by inserting the positioning latches
(Fig. 38, pos. 6) into the positioning holes (Fig. 37, pos. 3).
8.
Fasten the filter mat holder by tightening the knurled screw (Fig. 38, pos. 1) to the bolt with tapped hole
(Fig. 37, pos. 1) at the fan slide-in module.
Defective components may only be replaced by Kontron original spare parts.
Air filter mat: part number: 1050-8374.
38
www.kontron.com