Kontron KISS 2U KTQ87 - Manual (Page 31)

8. Installation and Removal KISS 2U V2 MB_SBC– User's Guide (Version 1.00)
8.2. Cover
The cover will be fixed to the chassis using two fixing brackets at the front side of the cover (Fig. 24, pos.3 and pos. 4),
two fixing brackets with captive knurled screws at the rear side of the cover (Fig. 24, pos.7) and the cover fastening screw
(Fig. 9, pos. 6) at the front side of the KISS 2U V2 platform.
When inserting the cover, make sure that:
‰ At the front side: the fixing brackets (Fig. 24, pos. 4) are inserted properly into the corresponding retaining bracket of
the chassis (Fig. 21, Fig. 22 and Fig. 23 pos. 1).
‰ At the rear side: the centring latches and the cover retaining plates (Fig. 21, Fig. 22, pos. 7 and 8, and Fig. 23 pos. 4
and 5) are properly inserted into the fixing bracket and centring slots of the cover (Fig. 24, pos.5 and 6).
The centering bracket (Fig. 24, pos. 3) and the front cover fastening screw Fig. 9, pos. 6) secure the cover on the front
side.The fixing brackets with knurled screws (Fig. 24, pos. 7) secure the cover on the rear side.
Fig. 24: Inside of the cover with fixing brackets
1 Inside of the cover
2 Front part of the cover
3 Angled centering bracket with tapped hole
(on the front side)
7
2 4
1
6
3
5
6
4 Fixing bracket (on the front side)
5 Fixing bracket (on the rear side)
6 Centring slots on the cover
7 Fixing brackets with knurled screws
In order to close the KISS 2U V2 platform chassis, ensure that the cover is properly reinstalled and
secured with following screws:
‰ the cover fastening screw (Fig. 9, pos. 6) and Fig. 25) on the front side
the knurled screws (
‰
Fig. 13, pos. 3, Fig. 15 / Fig. 16, pos. 6 and Fig. 26) on the rear side
www.kontron.com 29