Kontron KISS 2U KTQ87 - Manual (Page 25)

7. Product Description KISS 2U V2 MB_SBC– User's Guide (Version 1.00)
7.2.5. Grounding Stud
The grounding stud is located on the rear side of the KISS 2U V2 platform (see
Fig. 13, pos. 9 and Fig. 15 /Fig. 16, pos. 11).
The KISS 2U V2 systems with grounding studs marked with an “Earth” symbol (Fig. 19) have to be
grounded appropriate “common earth” connection point.
Fig. 19: Grounding stud marked with “Earth”symbol
7.2.6. Fan Slide-In Module and Temperature Sensor
The two system fans are securely installed in a user-friendly, interchangeable fan-slide-in module. The fan slide-in
module is mounted in the fan compartment on the front of the device (Fig. 9, pos. 2).
The systems fans are temperature-controlled via the temperature sensors which are built in the system. Thus sufficient
airflow is ensured for an optimal, active cooling of the system.
The operation of the KISS 2U V2 platform is permitted only with a functional fan slide-in module (refer
to the “Replacing System Fans” section).
Defective components may be replaced only by Kontron original spare parts.
‰
part number of the fan slide-in module: 1050-8442
7.3. Side View
On the left and right sides of the device, there are six M4 threaded screw holes, for installing the KISS 2U V2 platform in a
19" industrial cabinet using slide rails [not included; refer also to the chapter 11 “Slide Rails (Option)”.]
Fig. 20: KISS 2U V2 - side view
1 2 2 3
4
1 Side view of the KISS 2U V2 platform 3 Fastening screws for the card holder (the
position can be different ; see pos. 2)
2 3x two M3 threaded screw holes used for
mounting of card holder 4 4x M4 threaded screw holes (on both sides)
www.kontron.com 23