Accessing internal components, Installing /removing expansion cards, Fig. 26: loosen the knurled screw on the rear side – Kontron KISS 2U KTQ87 User Manual
Page 32
8. Installation and Removal
KISS 2U V2_MB_SBC – User's Guide (Version 1.00)
8.3. Accessing Internal Components
This section contains important information that you must read before accessing the internal components. You must
follow these procedures properly when handling any boards (refer also to the subsection 7.6.1 “Riser Card and/or
Backplane and available Bays”.
8.3.1. Installing /Removing Expansion Cards
Please consider following instruction when you install (or remove) expansion cards.
When you install (or remove) expansion cards please consider the corresponding safety instructions
(refer to chapter 4 “General Safety Instruction for IT Equipment” or the included “General Safety
Instruction for IT Equipment”).
The installation and removal of expansion cards have to be carried-out only by qualified specialist
personnel in accordance with the description in this manual.
Before removing the device cover, ensure that your system is switched off and disconnected from the
mains power supply.
Please refer to the ESD safety procedures for handling assemblies with static sensitive devices.
Failure to take heed of this warning instruction can result in damage to the device.
Please read information provided by the manufacturer of any expansion cards before installing them
or removing them from your system.
8.3.1.1.
Installing /Removing Expansion Cards into KISS 2U V2 with SBC/Motherboard (not Low-Profile Cards)
To install or remove an expansion card proceed as follows:
1.
Turn your system off and disconnect it from the main power source.
In order to remove the cover, unscrew the following knurled screws:
the cover fastening screw (Fig. 9, pos. 6 and Fig. 25) at the front side
the knurled screws (Fig. 13, pos. 3, Fig. 15, pos. 6 and Fig. 26) at the rear side
2.
Loosen the knurled screws, which secure the cover on the front of the system (refer to Fig. 25 and Fig. 26).
Fig. 25: Loosen the cover fastening knurled screw on the front side
Fig. 26: Loosen the knurled screw on the rear side
30
www.kontron.com