Kontron KISS 2U KTQ87 - Manual (Page 19)

7. Product Description KISS 2U V2 MB_SBC– User's Guide (Version 1.00)
7.1.2. LED Indicators
The LED indicators (refer to Fig. 9, pos. 5 and Fig. 11) of the KISS 2U V2 are located at the front of the device, behind the
front access panel.
2 HDD LED (orange)
1 Power LED (green)
1 2
Fig. 11: LED indicators
Power LED
(green) This LED (Fig. 11. pos. 1) is green when the system is switched on using the Power On/Off button.
Requirement:
The system must be connected to the power source (AC), using the corresponding power cable. The
power supply ON/OFF switch (if available), on the rear of the system must be set to “
ON“.
HDD LED
(orange) This LED (Fig. 11. pos. 2) is orange when the hard disk is accessed.
Do not press the eject button, while the drive LED is lit or flashing.
7.1.3. Ports on the Front Side
7.1.3.1.
USB Ports
KISS 2U V2 is equipped with two USB (2.0) ports on the front (Fig. 9, pos. 10 and Fig. 12). You can connect various USB
devices to these two USB 2.0 interface connectors.
Fig. 12: USB ports on the front side
7.1.4. Front Access Panel
The securing lock mechanism (Fig. 7, pos. 4) located at the access panel allows you, if required, to protect your system
from unauthorized use. When the access panel is locked, the cover of the KISS 2U V2 system can not be removed, and the
drives, filter mat holder and power button are not accessible.
If USB devices are connected to the USB ports on the front of the device, the front access panel can not
be closed and locked.
The key should be kept somewhere where it is not accessible to unauthorized persons.
www.kontron.com 17