Kontron COMe-cSP2 User Manual
Page 51
COMe-cSP2
/ Special Features
46
SD card compatibility
Due to the mechanical variability with different SD card manufacturers, Kontron recommends that miniSD cards from
the following vendor for use with the COMe-cSP2:
»
Transcend
»
Apacer
»
Elecom
»
Hidata
The use of miniSD cards from other manufacturers may cause difficulty when ejecting the cards from the on-module
mini SD card socket.
This note applies to modules of the following part numbers:
»
36003-0000-11-4
»
36003-0000-16-4.
SD recommendations
»
The SD_CMD line needs a pull-up resistor that can vary depending on the length of the electrical paths
(typical from 10kOhm to 100kOhm).
»
The maximum length for SDIO signals on the baseboard should be 80mm
»
SDIO boot is supported on baseboards following the maximum length specification for SDIO (80mm).
- CP3003-SA uEFI BIOS (72 pages)
- CP3003-SA (36 pages)
- CP3002 (38 pages)
- CP3002-RC uEFI (64 pages)
- CP-RIO3-05 (42 pages)
- CP3002-RC (30 pages)
- CP342 (52 pages)
- CP930 (46 pages)
- CP932 (52 pages)
- CP346 (72 pages)
- CP384 (66 pages)
- CP383 (74 pages)
- CP382 (58 pages)
- CP381 (60 pages)
- CP372 (64 pages)
- CP371 (60 pages)
- CP-RIO3-04S (38 pages)
- CP390 (36 pages)
- CPS3410 (9 pages)
- CPS3402 (9 pages)
- CPS3105 (9 pages)
- CPS3101 (9 pages)
- CPS3003-SA (19 pages)
- PB-SIO4 (34 pages)
- PB-SIO4A (34 pages)
- PB-DOUT8 (34 pages)
- VMOD-2 (82 pages)
- VSBC-32 (110 pages)
- VM42 (62 pages)
- Bootstrap Loader (24 pages)
- VMP1 with Netbootloader (120 pages)
- VMP1 (106 pages)
- NetBootLoader (86 pages)
- VMP2 (142 pages)
- VMP3 (154 pages)
- CP-RIO6-923 (32 pages)
- CP-RIO6-923-F (32 pages)
- CP-RIO6-001 (28 pages)
- CP-RIO6-001-HD-VGA (46 pages)
- CP-RIO6-M (20 pages)
- CP-RIO6-B (28 pages)
- CP6925 (42 pages)
- CP6002 uEFI BIOS (76 pages)
- CP6002 IPMI (40 pages)
- CP6002 (42 pages)