12 usb connectors (usb), Usb connectors (usb) – Kontron KTUS15-mITX - 1.1 Basic User Manual
Page 37

KTD-00774-G
KTUS15/mITX
Page 37 of 84
4.12
USB Connectors (USB)
The KTUS15 boards contain three Universal Host Controller Interface (UHCI) USB1.1 controllers and an
Enhanced Host Controller Interface (EHCI) USB2.0 controller.
A total of eight USB ports are supported. All eight of these ports are capable of high speed data transfers up
to 480MB/s, and six of the ports are also capable of FullSpeed and low-speed signaling (USB Ports 0, 1, 2,
3, 4, 5).
The KTUS15 boards support USB client functionality on port 2 of the USB interface. This permits the
platform to attach to a separate USB host as a peripheral mass storage volume or RNDIS device.
USB Legacy mode is supported. Over-current detection on all eight USB ports is supported.
USB Port 0 and 2 are supplied on the combined USB0, USB2 connector.
USB Ports 1 and 3 are supplied on the internal FRONTPNL connector (See FRONTPNL connector
description).
USB Port 4 and 5 are supplied on the combined USB4, USB5 connector.
USB Port 6 and 7 are supplied on the USB6, USB7 internal pinrow connector.
Note: It is required to use only HiSpeed USB cable, specified in USB2.0 standard: