FBT DLM26 User Manual

Page 62

Password User (default = “000000”)

Once entered the Password User, click on the “OK” button and the following window will open

Then select the Lock or Unlock position and Confirm the choice through the “Confirm” button.
If the button is set on Lock, after confirming the sw will lock the all parameters both of Input and

Output channels.
If the button is set on Unlock, after confirming the sw will allow the access to the all parameters

both of Input and Output channels.
Same function is offered by the following button

but here it is not necessary to set any Password and it is available for a quick Lock/Unlock when
operating by Remote Control Pc Sw and it is not affecting the Pc setting when back to the Stand

Alone mode.

The Lock/Unlock mode set by the use of the Password, will be operative on the Stand Alone device
also when not operating through the Remote Control Pc Sw.

Password SuperUser (Fix = “Suser1”)

Once entered the Password SuperUser, click on the “OK” button and the following window will
open

Then select the Enable or Disable position and Confirm the choice through the “Confirm” button.

If the button is set on Disable, after confirming the sw will not allow the “Lock/Unlock” function on
the parameters of single processes (in Super User mode, there is the possibility to Lock/Unlock

the access to the parameters of single processes...).
If the button is set on Enable, after confirming the sw will show a “lock” on top of the all

processes which parameters can be accessed or less (depending form the chosen Lock/Unlock
status), and this “focused” Lock/Unlock function is available ONLY on the Output channels.