FBT DLM26 - Manual (Page 18)

− Save a Program: this page allows you to store a new preset in the DLM26’s memory:
By pressing the ENTER button and rotating the “Param.2” or “Param.3” encoder, it is possible
to scroll through the previously saved presets and the available empty locations (identified by
“Empty Memory”).
If no user presets are stored, the “Save a Program” screen will show empty memory locations
for all
1-64 presets as shown in the example below for location 10:
When storing an edited configuration for the DLM26, select the location for a preset from the
64 available by using the “Param.2” or “Param.3” encoders.
Once the desired location appears on the screen press ENTER again to reach the “Set
Program Name” page.
In this page the User can enter a Preset Name (up to 16 Characters) by using the “Param.2”
or “Param.3” encoder to choose a character and the “NAV/Param.1” encoder to move between
the 16 available locations for the character’s positioning.
The current position of the cursor is shown by a “blinking underscore”.
The following is an example of a screen while entering the preset name “Stage 1 2x2” in
location 10:
To store the Preset Name press the “ENTER” button again.
The above action will take you to the “Enter to Save” page showing the selected location for
the preset and the final edited name:
Pressing “ENTER” again, will store the preset in the selected location with the chosen name
and the following transitory screen will appear on the LCD:
Save a Program
10: Empty Memory
Set Program Name.
10: Stage 1 2x2 ?
Saving to Memory.....
10: Stage 1 2x2
PROGRAM UTILITY
-- Save a Program --
[Enter] to Save
10: Stage 1 2x2 ?