FBT DLM26 - Manual (Page 33)

 Menu “Output 1/2/3/4/5/6” Output Channels Editing in “ Standard ” mode
[access by pushing the “1/2/3/4/5/6” buttons]
From the “Default Screen”, it is possible to access the “Output Channel” menu by pressing the “1”
or “2” or “3” or “4” or “5” or “6” button. Once pressed, the related blue “EDIT” LED will turn ON.
The Sub-Menus pages can now be scrolled through by rotating clockwise and counter-clockwise
the “NAV/Param.1” encoder.
For parameter editing it is necessary to press ENTER and an arrow will appear on the left of the
screen “->”. Then use the “Param.2” and “Param.3” encoders for selecting and setting the
parameter values. On some parameters that have three independent values, you will also need to
use the NAV/Param.1 encoder, for example for the filter’s parameter setting.
Note: All parameter editing can be done using the “NAV/Param.1”, “Param.2”, and “Param.3”
encoders and the current shown value of the selected option is AUTOMATICALLY loaded during the
encoders' use and stored as the current value once leaving the page.
Audio Signal Output (1/2/3/4/5/6) Path Block Scheme
HPF sub-menu – from this sub-menu it is possible to set the Output Channels High Pass Filter.
Once on the HPF page
Pressing the ENTER Button, the filter type fields and the Cutting frequency fields, become
accessible for the filter's type selection and the Cutting Frequency “fine” setting
The available shapes and orders for the High Pass Filter, that are accessible by rotating the
“Param.2” encoder, are listed below:
− Bypass (High Pass Filter Bypassed)
− Buttw_1st (Butterworth Filter 6dB/Oct Slope)
− Buttw_2nd (Butterworth Filter 12dB/Oct Slope)
− LRiley_2nd (Linkwitz/Riley Filter 12dB/Oct Slope)
− Bessel_2nd (Bessel Filter 12dB/Oct Slope)
− Buttw_3rd (Butterworth Filter 18dB/Oct Slope)
− Buttw_4th (Butterworth Filter 24dB/Oct Slope)
− LRiley_4th (Linkwitz/Riley Filter 24dB/Oct Slope)
− Bessel_4th (Bessel Filter 24dB/Oct Slope)
− Custom_2nd (IInd Order Filter Cell with editable Cutting Frequency and Q)
− Custom_3rd (Cascade of 2 IInd Order Filter Cells with editable Cutting Frequency on both and Q on the
second one)
− Custom_4th (Cascade of 2 IInd Order Filter Cells with editable Cutting Frequency and Q on both of them)
5 Band Multi Type
Equalizer
High and Low
Pass Filters
To X-Over
outputs
From Input
A/B
Delay Peak
Limiter
Pola
rity
G Eq
Byp
RMS
Compressor
Out-1 High HPF
Bypass F = 12500Hz
Out-1 High HPF
->Bypass F = 12500Hz