Elecraft KAT500 Owners Manual - Manual (Page 41)

38
On the edge of the pc board that has the rows of LEDs, install key caps on the three switches (S1, S2
and S3) as shown in Figure 30. Be sure you orient the key caps horizontally (parallel with the pc board).
Figure 30. Installing Key Caps on the Switches.
Locate the front panel and inspect the inside surface around the four screw holes (see Figure 31).
Remove any tape or residue to provide a clean metal surface.
Figure 31. Preparing the Front Panel for Installation.
Turn the KAT500 upside down on your table and mount the front panel as shown in Figure 32. Be
sure that all of the LEDs and switches pass through the openings in the front panel and that the tab at the
center of the front panel fits under the bottom cover, just as on the rear panel.
Figure 32. Mounting the Front Panel.