Elecraft KAT500 Owners Manual - Manual (Page 36)

33
Install the XMTR SO-239 connector in the rear panel opening marked XMTR as shown in Figure 20.
Take care not to bend the wire or move the solder lug. Place the flange of the connector inside the rear
panel, and orient the connector so the lug on the wire points toward the ANT1 connector opening as
shown.
Figure 20. Installing the XMTR SO-239 Connector in the Rear Panel.
In the same manner, install the remaining SO-239 connectors on the rear panel, starting with the
ANT3 connector at the end. Orient the connectors so the leads are as shown in Figure 21 and with the
connector flanges on the inside of the rear panel.
Figure 21. SO-239 Connectors Installed.