Elecraft KAT500 Owners Manual - Manual (Page 37)

34
Mount the ground terminal at the end of the rear panel next to the ANT 3 connector as shown in
Figure 22. Install the screw, lock washer and nut first and secure the nut so the screw cannot turn. Then
add the two flat washers and the wing nut.
Figure 22. Installing the Ground Terminal.
If there is an opening next to the XMTR SO-239 connector as shown in Figure 23, install the BNC
hole cover in the opening. Press the cover in until the ears on the plug lock it into place. This opening is
“D” shaped. If needed, cut the plug section as shown to fit in the hole.
Figure 23. Installing the BNC Hole Cover.