Elecraft KAT500 Owners Manual - Manual (Page 27)

24
Assembly Procedure
Before starting construction, do a complete inventory, comparing the parts in your kit with the parts
list in Appendix A, to familiarize yourself with all of the parts and to ensure the kit is complete. If any
parts are missing contact Elecraft for a replacement (see Customer Service and Support, page 1).
Taking ESD precautions remove the printed circuit board from its ESD-safe envelope and install six
2-D fasteners as shown in Figure 7. Be careful not to disturb any of the inductors on the top side,
especially the air wound coils, or the position of the resistor mounted on the bottom.
Figure 7. Installing the 2D Fasteners.