Dynojet 250iPX: Installation Guide User Manual
Page 29
M O D E L 2 0 0 I P X / 2 5 0 I P X U P G R A D E
Drum Installation
Version 1
Model 200iPX/250iPX Upgrade Installation Guide
1-21
I
NSTALLING
THE
R
IGHT
B
LOWER
M
OUNT
AND
B
LOWER
A
SSEMBLY
You will need the following parts:
• 37513200
Anchor, Redhead, 3/8" (4)
• 76950317
Blower Extension Cord
• DM150-002-007
Washer, 5/16", Flat (4)
• DM150-019-012
Bolt, 3/8-16 x 1", Hex (4)
1
Mark the right blower mount placement as shown in Figure 1-16.
2
Using the blower mount as a template, mark and drill the four holes needed to
secure the blower mount to the floor.
3
Install the Red Head anchors. Refer to Appendix A for installation instructions.
4
Secure the blower mount to the floor using four 3/8-16 x 1-inch hex bolts and
four 5/16-inch flat washers.
Figure 1-16: Install the Right Blower Mount
right blower
mount