Dynojet 250iPX: Installation Guide - Manual (Page 27)

M O D E L 2 0 0 I P X / 2 5 0 I P X U P G R A D E
Drum Installation
Version 1 Model 200iPX/250iPX Upgrade Installation Guide
1-19
I NSTALLING THE I PX D RUM M ODULE
You will need the following parts:
• 37620622 Woodruff Key (2)
• 62240070 Driveline Assembly
• 63200002 iPX Drum Module
1 Place the nylon loop strap around the shaft on either side of the drum module.
2 Using a forklift, lift the drum module from the crate and place the drum module
in the pit with the stepped end of the shaft towards the dyno. Make sure the
panels on the drum module and the dyno are parallel.
3 Remove the two existing screws from each side of the dyno frame where the
connector plates will attach.
4 Insert the woodruff key into the keyway on the drum module shaft.
5 Insert the woodruff key into the keyway on the dyno shaft.
6 Slide the driveline over the key on the drum module shaft.
7 Keeping the panels parallel, slide the drum module towards the dyno. Slide the
driveline over the key on the dyno shaft. You will need to support the driveline as
you slide it onto the dyno shaft.
8 Continue sliding the drum module towards the dyno until the side panels on the
drum module and the dyno are flush.
Figure 1-14: Install the Driveline and the Drum Module
existing screws
iPX drum module
driveline
woodruff key
woodruff key
existing screws