Detex AO19-3 - Manual (Page 3)

Receiving Inspection
Contact Factory on damages and missing equipment
Installation Preparation
104854 Page 3
REMOVE THESE TWO SCREWS
AND KEEP TO BE USED AGAIN
3-Position
Swtich
Assy.
(105422)
UDC 1000
Controller
(105421)
Line
Filter
(105416-2)
UDC 1000
Controller
(105421)
Detex Part # - 12515-X
Verify that the device ordered is the correct model for the door application. Inspect package for
possible shipping damages. Carefully cut tape and open cardboard shipping box. Packed into
this box you will typically find arm assembly, door decal(s), header assembly with controls and
associated wiring and instruction documents. The operators are shipped separately in individual
boxes. Remove items and place them carefully aside so they will not be damaged or lost. Using a
#2 Phillips, remove the cover screws and lift cover. Remove packing and inspect
all items before continuing.
The hanger bracket assembly is unique to the Detex Low Energy Automatic Door Operator. It
allows the installation to be performed by one person, quickly and efficiently.
Locate Phillips screws inside at the top corners. Remove these (screws will be used again) and
separate the enclosure from the hanger plate.