Detex 14DN Trim User Manual
Page 2
DETEX INS-101296 Page 2
PREPARING THE TRIM
1. The lever trim is handed. Refer to "CHANGE LEVER HANDING" on page 4 if needed.
INSTALLING THE MORTISE CYLINDER -08 and 09 FUNCTIONS ONLY
2. A short cylinder collar is supplied for mortise cylinders 1" to 1-1/8" long. For cylinders greater than 1-1/8", order
tall collar p/n 100752-x.
3. Insert the mortise cylinder (not included). (See Fig T8). Fasten the cylinder with the large hex nut from the hardware kit.
Note: The key should turn the cylinder cam easily to slide the locking bar in both directions.
Caution: The back of the cylinder should not protrude beyond the depth of the trim escutcheon.
PREPARING THE TRIM - CONTINUED - FOR 08 FUNCTION, 09 FUNCTION AND 14 FUNCTION:
4. Attach the tailpiece extension assembly to the top gear with screw provided.
PREPARING THE DOOR:
5. Center punch holes "a" and "d" marked earlier.
6. Drill two (2) pilot holes "a".
Caution: Be sure to drill STRAIGHT through the door.
7. Drill pilot hole "d".
Caution: Be sure to drill STRAIGHT through the door.
8. At the outside and inside hole "d", drill a 3/4" hole.
Fig. T8