Salter Brecknell 7550 - Manual (Page 14)

Error Messages
11
Flashing Flashing Flashing Flashing Flashing
*
* * * *
Sealed Sealed Sealed Sealed Sealed
C a n ' t C a n ' t C a n ' t C a n ' t C a n ' t
L.C. Error L.C. Error L.C. Error L.C. Error L.C. Error
– – – – – – – – – – – – – – – – – – – – – – – – –
Auto. 0 Auto. 0 Auto. 0 Auto. 0 Auto. 0
O.LoAd O.LoAd O.LoAd O.LoAd O.LoAd
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The following are displays you may see if problems occur, or if invalid
operations are attempted with your WI-127:
Display Description
Overrange weight
Underrange weight
Recovering from lockup or out of range condition
A-D converter is not functioning
A-D converter subjected to an input signal
beyond ±5 mV/V
The unit cannot perform a function. Displayed
only while key is held down.
Corrupted data in the reset menus. See the
Reset Menu/Master Clear section. (* = RESET,
SETUP, or CAL).
Displayed while a key is pressed when attempting to
modify a sealed selection without edit privileges.
Displayed while waiting for a stable, valid weight to
use as a zero reference on power-up.
Displayed when input voltage to excitation regulator
drops below 10.5 VDC. Will clear when input voltage
rises above 11.5 VDC.
Loc' up Loc' up Loc' up Loc' up Loc' up
Lo. Volt Lo. Volt Lo. Volt Lo. Volt Lo. Volt