Changing the print quantity after taking a shot, Set the print quantity, Complete the setting – Canon IXUS Z65 User Manual

Page 43

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Specifying the Print Quantity

Changing the Print Quantity After Taking a Shot

Seiect the mode for
specifying the print quantity

for the previous frame.

• Press the Q button ® and

then press the SELECT button

(D for at least 2 seconds

^ "P-0” (no prints) blinks on

the LCD panel

p r ? -

DATE

£^a I

Set the print quantity.

• Press the button

• Each lime you press the

button, the setting changes
sequentially from P-1, to P-2,
through to P-9 and then back

to P-0, P-1, etc

• Hold the button down for 2

seconds or more to cycle

continuously through the settings.

Complete the setting.

• Press the

SET

button

^ The film rewinds 1 frame and

the print quantity specification
lor the previous frame Is

replaced

• The date/time display reappears

• If you switch the camera off before completing the

setting, the setting reverts to its previous value.

• If you replace the battery, the date and time display

on the LCD panel reverts to three blinking dashes
(“.......... ") and you cannot specify the print quantity.