Canon IXUS Z65 - Manual (Page 39)

Setting the Date and Time
Setting the Time
Display the date and
• time.
• Press the DATE button to
display the date and time
H 36)
• Refer to the previous page
to set the date
Select the time setting.
• Press the SELECT button to
select the setting
^ The selected setting
(blinking numbers)
changes sequentially from
hour to minute to second
(colon " : ")
Set the time.
• Press the SET button to set
the time
• Repeat steps 5 and 6 to set
all the time settings.
• If you press the SELECT
button and the colon “ : "
does not blink, time setting
is complete. •
• If you replace the battery, the date and time display on
the LCD panel reverts to three blinking dashes (".....................
(no date or time imprinting). When this occurs, perform
steps 2, 3, 5 and 6 to set the date and time.
• Holding the button down for 2 seconds or more
causes the setting to change continuously.
• If you press the SET button when the colon “ : " is
blinking, the seconds display is set to zero.
□-39