Canon IXUS Z65 - Manual (Page 42)

^Specifying the Print Quantity
This feature allows you to specify the number of prints (0 to
nine) of a frame to be produced at one time. This is useful as it
saves the trouble of having additional prints made and can be
used to avoid getting prints of unsuccessful shots
Note that you can only set or change the print quantity for the
frame about to be shot (next frame) or the frame just shot
(previous frame).
• When you load negative film, the print quantity is
automatically set to 1 (P-1).
• When you load reversal film, the print quantity is
automatically set to 0 (P-0).
• Always use the push-button projection on the strap
buckle to push the SELECT, SET and iS buttons. 13)
Setting the Print Quantity For the Next Frame
1
i
& A
SD [|]
±2___
.______ . 1
Set the print quantity.
• Press the button.
^ Each time you press the
button, the setting changes
sequentially from P-1, to P-
2, through to P-9 and then
back to P-0, P-1, etc. (This
cycle begins at P-0 when
reversal film is used,)
• Hold the button down for 2
seconds or more to cycle
continuously through the
settings.
Take the picture.
^ After you shoot a frame,
the print quantity
specification reverts to the
default setting of 1 print (0
prints for reversal film),
0-42